The unsurpassed quality and rugged construction of the BULK-FLO™ conveyor series assures years of dependable service even under the most severe conditions.
Each system is individually designed for your specific application from standard components that are robotically welded in jig fixtures to provide interchangeability and smooth operation.
All head and tail sections are maintenance friendly and wear parts are easily replaced.
Key Features
Pre-assembled
All conveyor sections are pre-assembled on a level 215ft fixtures, match-marked and dowel-pinned for field assembly. With proper rigging practices, Intermediate Sections can be assembled and shipped in multiples of up to 40 ft. lengths, saving on field time
Durable finish
~3 mils Powder Coat finish. The finish has a good hardness, excellent flexibility, excellent exterior stability, good chemical and solvent resistance, and a very good corrosion protection. All parts are powder coated before assembly. All fasteners are cadmium plated
Wear reduction
All liners use 1/2" welded studs attached to the exterior of the liner plates to eliminate wear points on the inside of the liners
Easy access
Head and tail housing assemblies are split for easy access
Mounted bearings
Out-board mounted bearings on the head section
Adjustable
Rex ZT center pull take-up bearings on the tail section. Shaft seals are a Rino adjustable "packing-gland" split type
'G' style head
'G' style head sections come with a plug relief door and switch
Internal conveyor split
All internal conveyor sprockets are split and hardened to ~420 BHN. Split sprockets can be "turned around" for double life. "Walking Tooth Sprockets" used where applicable
Cotter-constructed
Conveyor chains are all Cotter-constructed for ease of removal. All links are pre-heated prior to robotic welding of the attachment bars
Easy removal
Conveyor "By-Pass" inlets have a bolted side plate construction to ease removal/replacement of the internal liner plates without removal of the feed spout and or transition
Robotically welded
All intermediate sections are pinned and robotically welded in fixtures to ensure squareness and length